Eagle Access Control Systems Eagle-E7 User Manual download pdf (Page 15)

Eagle Access Control Systems, Inc. www.EagleOperators.com

POWER FAIL OPERATION

INSTALLATION

In the event of a power failure, your Eagle-DC Gate Operator will operate on battery

back-up until AC power is restored or the batteries are completely discharged. Al-

ternatively your Eagle-DC gate operator can be set up to “hold open” (fail-safe) or

“hold closed” (fail-secure) until AC power is restored.

Following is the procedure for proper set-up of:

• BATTERY BACK-UP OPERATION

• AC Power Failure

- HOLD-OPEN or HOLD_CLOSED During AC power failure

• COMPLETE BATTERY DISCHARGE

BATTERY BACK-UP OPERATION

When installed correctly, your Eagle-DC

Gate Operator can provide up to 100 cy-

cles of operation during an AC power

Failure (Actual cycle count will vary

based on your gate and site conditions .

Consult your installing professional for

estimated number of cycles for your

gate system.

FOR BATTERY BACK-UP OPERATION

STEP 1. Find DIP Switch Panel Labeled

“PWR FAIL OPERATION”

TEP 2. Turn Switch 1 to the OFF position

RESULT. When AC power fails, the gate will remain opera-

tional until AC power is restored or battery voltage drains

minimum (see page 17).

PWR FAIL OPERATION

Battery Back-up Operation:

Switch 1 AUTO OPEN

OFF

RESET

Note:

Press RESET after

each programming

change

1 2 ... 10 11 12 13 14 15 16 17 18 19

No comments

Eagle Access Control Systems Eagle-E7 User Manual Page 15